American-energy-systems PP-1030-LR Wire Harness User Manual download pdf

F:\AESBusinessSystems\AES Technical\Piece part instructions\PP-1030-LR Wire Harness Assembly LR01.doc

Wire Harness Assembly

Part #PP-1030-LR

For Models LR-01 (prior to 2011)

• Unplug unit.

• Open both side panels.

• Remove existing wire harness.

• Attach the following:

o Control Board molex connector

o Exhaust Fan gray/white & black molex to black leads

o Auger Motor brown/white & black to black leads

o Room Air Fan blue/white & black molex to black leads

o Vacuum Pressure Switch green lead to top terminal violet lead to bottom terminal

o High Limit Snap Disk gray lead to top terminal violet to bottom terminal

 all white snap disk

o Snap disc right side yellow wire to top terminal violet wire to bottom terminal

 yellow & white snap disk

o Proof of Fire Snap Disk brown wire to top terminal violet wire to bottom terminal

o located by exhaust motor yellow & white snap disk

o Electrical Plug double white wires middle terminal black wire bottom terminal

green wire to top terminal other end of green wire screwed to base

of unit

o Igniter red wire to one lead white wire to one lead

o thermostat blue lead and red lead (these are not used if NO thermostat)

• Plug unit in

• Turn on unit

1 2 3

F:\AESBusinessSystems\AES Technical\Piece part instructions\PP-1030-LR Wire Harness Assembly LR01.doc Wire Harness Assembly Part #PP-1030-LR For Mode

Page 2

F:\AESBusinessSystems\AES Technical\Piece part instructions\PP-1030-LR Wire Harness Assembly LR01.doc high lim

Page 3

F:\AESBusinessSystems\AES Technical\Piece part instructions\PP-1030-LR Wire Harness Assembly LR01.doc

No comments

American-energy-systems PP-1030-LR Wire Harness User Manual