American-energy-systems MF3553 Auger Inspection User Manual download pdf

F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3553 Auger Inspection.doc

Auger Inspection

Part #MF3553

(inspection of Countryside augers )

• Verify auger free of gouges, nicks, scratches and dents fix if possible.

• Verify auger free of rust and excess oil, if necessary use wire brush to clean and then wipe auger down

with paint thinner to remove all oil. Then lightly oil.

• Verify auger

flighting pitch

dimension from

right to left can not

decrease. It may

increase within

tolerance

progressively but

not decrease.

• Verify all burrs and sharp edges have been removed.

• Inspect all welds they must be neat, smooth and good penetration from flighting to shaft.

• Using bench grinder

remove a 1/16”

from both ends

approx. 2” in as

shown.

• Verify outside diameter of flighting is uniform and fit

correctly in auger tube as shown. Using a flashlight

position behind auger and spin the auger making sure

flighting is uniform.

F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3553 Auger Inspection.doc Auger Inspection Part #MF3553 (inspection of Countryside auge

No comments

American-energy-systems MF3553 Auger Inspection User Manual