American-energy-systems MF3650 Exhaust Blower User Manual download pdf

F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3650 Exhaust Blower 2-

speed.doc

MF3650 Exhaust Blower 2-speed

All Magnum units that may require extra CFM when installed (see below)

1. It provides more air movement through the unit when combustion air and venting

configurations are limited

2. It is usually added to stoves that are in areas of higher altitude to assist in proper

combustion.

3. Can or should be used on installations that have longer horizontal exhaust runs.

4. Adapts the unit for new high ash content fuels that are emerging in the market.

5. Can be used as a replacement for CF3542 or MF3542.

6. Use jumper wires as needed.

• Turn off power on control panel and unplug from the power supply.

• Disconnect the exhaust blower leads from the wire harness make sure when pulling off

wires that you use pliers by the end of the terminals, so you don’t pull out the wire from

the ends.

• Remove existing exhaust blower.

• Remove existing exhaust tube from the

exhaust blower being replaced.(save the

#8-tek screws for later use)

• Clean the rectangle outlet of the exhaust

tube of any old high temp silicone.

• Place a 1/8” bead of high temp silicone

on the rectangle outside edge of the

exhaust tube.

Back side of blower Front of blower

Connection Diagram

Wht-Common

Blk-High

Red-Low

1 2 3

Page 1

F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3650 Exhaust Blower 2-speed.doc MF3650 Exhaust Blower 2-speed All Magnum units that may

Page 2

F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3650 Exhaust Blower 2-speed.doc • Slip rectangle end of the exhaust tube over the recta

Page 3

F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3650 Exhaust Blower 2-speed.doc • Remove any loose debris from the exhaust t

No comments

American-energy-systems MF3650 Exhaust Blower User Manual